T1 Max

The real obstacle for abrasives is the toolhead, not what the other people said. If you print pa6 cf with the current toolhead but replace just the nozzle to a hardened one, the filament detector is going to get destroyed first, then the 3 hole cht style heatbreak and lastly the non hardened extrude

100% worth it. That printer goes for $500 on their website. But it is a gamble, like all of flsun's printers. IMO the max isn't better than the t1 or t1 pro because of the lack of an enclosure.

I ordered 2 (two) S1's on Nov. 23rd, they both arrived this past Tuesday (16th) via FedEx, which is an expensive way to ship two oversized boxes that weigh approximately 100lbs a piece...just sayin. Further, I'm not entirely certain where/who started this whole 'out of business' rumour but, it's not

There is nothing out there that can push 90mm3. There is no filament that can verify that the t1 can even push it either. Some people have claimed 60mm3, but I personally have only gotten 47. That being said, 47 is very fast. Bambu p1 and x1's are pushing 25-30mm3, and users talk about how it's the

Buy a second-hand T1 Pro without warranty direct from FLsun and use it as a source of spare parts. Should cost $149 plus shipping. Or pay extra for warranty. I believe if you order $199 or more shipping is free.

I'm putting on a Dragon Burner with a V6 hotend I had sitting around and a Biqu Nebula extruder that looked cool. To make this work, I printed AfterBearner X gantry parts, which move the rods closer together so the extruder motor can sit above the rods. I'm swapping the board with a BTT SKR V1.4 Tur

Been hearing a lot lately about flsun ghosting. Makes me want to out my t1 pro on ice for a bit in case I need parts. As far as i know these machines can be flashed back to previous firmware but I could be wrong, been a while since I was told that. If you updated through the machine screen you may b

This is a pic of the mainboard on the FLSUN_T1. The mosfet is bottom right. Notice it has only two pins soldered because the middle was snipped and heatsink instead is used. It's was difficult to replace without damage to pads so be careful.

Have you looked at the Centauri carbon? I have a Bambu x1c, 2 elegoo resin printers, 2 flsun t1 pros, and a Centauri carbon. My least favorite are the flsuns. I hate them. I always have to tinker with them. They don’t print as accurately. Good maybe for figurines and ornamental parts. Forget functio

I heard back from FLSun. Support last week, trying to find an Effector base plate for my T1 Pro that has one stripped screw hole for arm retention. They said out of stock but will let me know if they find some. At least I got a response quickly, so many on here saying they are swirling the drain. Th