T1 Max

I think the duct you ended up using ("square" with four arms) is his own design, called the MaxAir as I recall. I liked that one too, but ended up switching to the Sweeper for much better nozzle visibility and it's no louder for me. I don't know if any of these would fit the T1 Max if they changed t

I ordered 2 (two) S1's on Nov. 23rd, they both arrived this past Tuesday (16th) via FedEx, which is an expensive way to ship two oversized boxes that weigh approximately 100lbs a piece...just sayin. Further, I'm not entirely certain where/who started this whole 'out of business' rumour but, it's not

I found a Bambu intake muffler a guy made that was huge, resized it for the intake on the CPAP, newer position, this is the T1 Pro - took out the high pitched noises is all no volume decrease. But, kept trying different print fan ducts and the 4 ‘nozzle’ one the Needit/Makeot guy did seems to work t

Thanks! My P1S with ams has been a great machine so far, 10 months without problems (except the motherboard fan making a lot of noise, but they sent me one under warranty) only recently I had issue with it, grease got on the belts, cleaned them, all fine now, except it layers shifts on the first col

Hi, Over-Poem After coming up empty for an alternative solution for alternate sources, I had no solution but to wait on FLSun. FLSun did finally send me a new 1) main board, and a 2) Steeper as a replacement. It took awhile since it came from China, and many back and forth emails, logs, etc. About 2

I mean no direct offense pard' but..." Without a carbon filter?...and dead pets" Is that really necessary pard'? A wee bit harsh but apparently you feel slighted. Box checked. I will confess, adding FLsun Delta style printers to my farm has been an adventure, but to be honest, an educational adventu

This guy went crazy on the number of arms options but seems to have done a pretty good job https://makerworld.com/en/models/559282-flsun-t1-part-fan-ducts-1-duct-to-5-ducts?from=search#profileId-478439 I'm using this one - the Need It / Make It guy is great! It prints overhangs much better and does

This guy went crazy on the number of arms options but seems to have done a pretty good job https://makerworld.com/en/models/559282-flsun-t1-part-fan-ducts-1-duct-to-5-ducts?from=search#profileId-478439 I'm using this one - the Need It / Make It guy is great! It prints overhangs much better and does

(Part 2) Yes Elgoo carbon "CAN" be loud -- in all fairness and rainbows (as reported when fans are MAXED 100%)... but for normal PLA operating the DBs sound is less then ~50dbs or LESS - likely less, 40's dbs to be fully fair, and no bias... but again, its NOT 65-70+dbs ALL THE TIME like the FLSun T

Same for me on the T1 Pro and a quality oil helped. That said is it happening on multiple models? I had a popular model make those sounds especially on lower layers to the point I stopped it, realized it and tried again, some better but still noisier than normal. Then I did a different model and no