T1 Max

I heard back from FLSun. Support last week, trying to find an Effector base plate for my T1 Pro that has one stripped screw hole for arm retention. They said out of stock but will let me know if they find some. At least I got a response quickly, so many on here saying they are swirling the drain. Th

The real obstacle for abrasives is the toolhead, not what the other people said. If you print pa6 cf with the current toolhead but replace just the nozzle to a hardened one, the filament detector is going to get destroyed first, then the 3 hole cht style heatbreak and lastly the non hardened extrude

I'm sorry to hear that! The newest flsun series of printers hasn't been the most reliable printers, but if they get slown down alittle and the reliability and quality goes way up. Here is my profiles for the T1 and T1pro.. Free to download and use. https://www.printables.com/model/998756-flsun-t1-an

All be forewarned on FLSun, we have 2 T1 printers, both failed within the factory warranty period but FLSun refused to repair or send parts on the warranty. They dropped support for the T1 when they introduced the T1Max. If you buy the T1, make sure to get the Micro Center extended warranty.

Thanks! My P1S with ams has been a great machine so far, 10 months without problems (except the motherboard fan making a lot of noise, but they sent me one under warranty) only recently I had issue with it, grease got on the belts, cleaned them, all fine now, except it layers shifts on the first col

Hi, Over-Poem After coming up empty for an alternative solution for alternate sources, I had no solution but to wait on FLSun. FLSun did finally send me a new 1) main board, and a 2) Steeper as a replacement. It took awhile since it came from China, and many back and forth emails, logs, etc. About 2

Story time! I bought a t1-u in December and it burnt out in April. Begged for service and they shipped my printer to nj and back and there it was upgraded to the t1 pro T1 pro worked until July until the same motherboard burnt out. This time they wouldn’t refund me so I had to make posts online unti

I used to set print temp the same way (esun PLA+ recommended 215, range 210~230) when I first started printing with Kingroon KP3S Pro about 2.5 years ago, kinda miss that out-of-box experience. I mean, look at this top layer of this print! This was literally silk smooth when I rub my finger against

Been hearing a lot lately about flsun ghosting. Makes me want to out my t1 pro on ice for a bit in case I need parts. As far as i know these machines can be flashed back to previous firmware but I could be wrong, been a while since I was told that. If you updated through the machine screen you may b

This is a pic of the mainboard on the FLSUN_T1. The mosfet is bottom right. Notice it has only two pins soldered because the middle was snipped and heatsink instead is used. It's was difficult to replace without damage to pads so be careful.