K1 SE

I have a 2024 model k1-se, I have done and would recommend the following depending on your wanted outcome. General printing: Official Creality enclosure - will allow for printing high temp filaments and minimize warping Side mount spool holder (printable) - rear mount spool is frustrating depending

Just got one for Christmas so here is my insight: Third party extruders like DXC aren't natively supported. There are different upgrade kits for different models, I have a K1 SE modded as a K1C and not sure what upgrade kit I got, but it required some minor modifications to the cable chain mount to

"só que vejo algumas pessoas tendo sérios defeitos com impressoras da creality" Entra em grupos de outras marcas também que vai ver a mesma coisa kkk Eu já tive uma K1 e ela é bem chatinha mesmo, principalmente com PLA se inventar de imprimir com a porta fechada quando claramente tem um adesivo que

I was in the same boat as you. Almost got the Elegoo CC, then they went back on all their promises. Then I found the Creality K1 SE. It was $100 cheaper also. It's basically an updated version of the K1 and k1C, but it doesn't have an enclosure, side cooling fan, exhaust fan, and camera. Currently I

I got the K1 SE as my first printer, and I've had zero issues with it like everyone has been saying about Creality printers. The only issues that have come around have been my own mistakes. My printer performs even better than I expected, and has printed PLA, PETG, TPU, ABS and PC with no issues, ev

Got one but from eBay. Screen was replaced looks new, few scratches around, also notice tension were replaced. Was getting clogged so upgraded to Creality DXC Extruder, K1 SE/K1C/K1/K1 Max Upgrade Extruder Kit. Been Amazing, I have P1S but K1 max bed side is amazing. As fast as my P1S with great qua

The answers to the PLA problems with Creality always seems the same. Open the top to let out the heat that collects up there. There is also a heatsink that can be added to the extruder motor on the K1, might be a gimmick, but it kept my motor a little cooler on my K1 SE. Another thing you might try

I did not buy the upgraded extruder, so I don't know if it works any better. I just bought new metal gears for the stock extruder and it fixed the problem for now. If it happens again I will buy the Creality Official Upgrade K1C/K1 SE/K1 Max Extruder On Amazon for $23 but the gears i bought were lik

Not bad. That's close to my K1 SE and K1 Max at PLA Temps. They didn't need much adjustment on the Belt SkipMy K1C was a Sky Ramp that bowed up on the sides. That took some skips to get right. It still is a little taco, but well with in tolerances now. May have to adjust a side down alittle, the fle

Did u ever figure this out? Almost all my prints on the K1 have bad angled overhang surfaces. (Not the surface that is usally on top of the supports) it happens on both my K1C and K1 Se, the creality regular slicer didnt have this issue. However i cant revert due to me having a custom macro for the