Kobra S1 Combo

Eu tenho uma k1c, ela imprime material de engenharia, a versão C possui bico endurecido para material com carbono. Minha opinião sincera, é uma impressora boa, imprime tudo sem dor de cabeça, mas ela tem alguns problemas que vc precisa ficar atento, mas é possivel imprimir coisas ou fazer upgrades p

Dude. Upgrade that dang ender first. It’ll surprise the hell out of you. The upgrades available today are 10x better than what was available back in 2020 🙌 my e3pro has the 4.2.7 silent board running a basic compile of marlin 2.0.1, dual z, MS direct drive kit, TH3D EZABL Pro (installed, not connect

That’s an interesting assumption. You’d be wrong. But interesting nonetheless. Honestly, no clue what caused and I likely won’t until I get the blob off and take a look at the nozzle. I had this happen on my old Anycubic Kobra S1 printing PETG-CF and it was because the nozzle started leaking (someth

A bed like that is probably easily corrected by adjusting the z-screws. Though this should've been done at the factory. https://wiki.anycubic.com/en/fdm-3d-printer/kobra-s1-combo/nozzle-scraping-hot-bed

Fwiw I love mine, minor grumbles and all - my first FDM so it's been a learning experience. If I had any advice, it would be the common issues I've seen popping up here and experienced myself: - Be wary when changing/removing/replacing hotends - be sure to seat the hotend all the way up when you pul

You can troubleshoot it but if you have it under warranty, claim it and just get a replacement. The beds often taco themselves (I bought funssor bed and gantry to solve this issue) and the hotends are extremely bad (I bought microswiss to solve this). If you want it working as advertised you do have

before the P2S Combo i owned the Kobra S1 Combo for 11 Months & 650 hours. YOU DODGED A BULLET. The Printer is even worse than a OG Ender. You cant even Troubleshoot problems cause the problems are random AF. Like first Print will fail horrificly and if you press Print again without changing ANYTHIN

Tenho anycubic Kobra s1 combo, o meu maior problema foi coma primeira camada, mas co seguib resolver com uma pei mais rigida, até o momento n tive problemas com ela e atualmente estou fazendo 200 lembrancinhas pra escola da minha esposa e a impressora está ficando ligada 24h por dia imprimindo, todo

giant mistake. I also made this mistake with my Kobra s1 combo. 650h of wasted filaments and constant problems. If you even do a little research you find quickly find out to avoid anycubic. I got scammed from all Anycubic reddits and anycubic themselves. Go with the elegoo CC. i know tons of people

The Kobra X is my third printer out of four. Since I also own the S1 Combo, the Kobra 3 and "soon" the S1M I can see how Anycubic has evolved in terms of design, improvements, firmware, and hardware. Unfortunately, there are a few users who have come forward to discuss issues with this printer, but