Deco XE75

I have 2 Deco XE75 units. The primary is obviously hardwired to the modem. The 2nd unit is hardwired upstairs. At the wall port I get 500+ Mbps, which exceeds what I pay for through Spectrum. When I hardwire to the 2nd Deco port I don't even get 100 Mbps. What could be going on and possible sol

This post is essentially meant to express my profound regret for purchasing the Deco XE75. I had been using the M5 for five years, and while I was generally satisfied with its performance, its coverage was quite limited. Consequently, I decided to upgrade to the three-pack XE75, which offered improv

Hey r/Bell community, I'm reaching out because I'm hitting a major speed wall and could really use the collective knowledge here.

The Problem: I'm on a 3 Gbps plan with the GigaHub, and my network speeds are nowhere near what they should be.

My Current Setup (PPPoE Passthrough):

• GigaHub is in its

My XE75 Pro 3 node mesh is hardware version 2.0.

TL;DR - If your XE75 Pro hardware is v2.0, stick to firmware 1.2.9 Build 20231225 unless you want to risk dealing with constantly offline nodes. Manually downgrading is very possible as long as you can go to each node's web interface and upload the

Hi Everyone,

Not sure if this is the correct sub for this query. I have two Deco XE75 units, one paired with the main modem and the other unit connected to the first Deco unit in the living room through ethernet backhaul. The living room unit is then connected to various devices like my PC, PS5 an

Hi I have three Deco Xe75. This weekend I suddenly had trouble with my network. I tired a lot of things but finally figured out one of them is defect, at least I think. I have all three cabled, but now, when ever I put an network cable in it, it will flash red after a while, no matter wich port I

Hi, I picked up a set of Deco xe75 mesh routers. I am finding that when connected hardwire to the main deco, my speeds are only half of what I am paying for. Are there any adjustments that I can make in the unit to make this better? I am connected to the modem using a CAT6 cable. Thanks

Hi, I have the AXE5300/XE75 and the 3 ethernet ports were working fine on my Main unit. But the highest ethernet port stopped working yesterday for some reason. I even switched out my main unit with another Deco which I made the new "main" - same problem with the 2nd unit. I tried switching ether

UPDATE: it turns out that one of my XE75 units had a faulty Ethernet port. Once I replaced the main unit with another XE75, DHCP for wired devices started working properly with the new main unit handing out addresses.

UPDATE 2: *it's been nine days and the system has been rock solid. Very happy tha

Same here, my 3-unit Deco XE75 worked flawlessly for 2 years and now the top port on one of the satellite units is dead. Well, not really dead but in a zombie state. The Deco app says that my Mac is connected, but the Mac isn't being assigned an IP number like my two other Macs connected to ports 2+