MK4S

You can sell it, there is probably some customer base with mk3 and mk4 that may consider it for right price. I believe for various reasons enclosure for mk4 was really dead end. The Biggest issue is to volume you have to heat up, location of the printed part on the bottom due to printer construction

I have a Prusa MK2 that I can turn on and print like new, if I wanted. It has 28k hours and I've only replaced belts once, and fans due to bearings wearing out. I have three MK3s with more than 15k hours each, one near 20k. Again, only a few fans, one extruder because of my own dumb mistake. My MK4S

I've had a Core One upgraded from MK4s for 4 months. The only problems from your list I've experienced are the gantry squaring, and prior to the fixes Prusa made there were minor VFAs in some prints, now gone. There's definitely an assembly problem if your nextruder main plate wore out in 2 months.

You summarize why I went with a Bambu printer and not a Prusa. I need a bigger printer. If Prusa had released their L sooner instead of the Core one, maybe I would have took that route. But then, with what Bambu is offering, and even Qidi, I don't feel like Prusa is there anymore. For absolute fabs,

This just tells me you haven't used a Prusa with Prusaslicer. Here is an image of woodfill PLA printed on a fully calibrated Bambu X1E vs a Prusa XL with zero calibration aside from the original setup. Prusa on the right. Here is an X1C vs a Prusa MK4 using bambu woodfill PLA.. The Bambu on the left

I'm sure they're currently working on the fix, because such an "apparently "simple issue leaves their reputation in jeopardy and many customers are dissatisfied to the point of returning the printer. Now Prusa proudly shows the low number of printers returned by customers, but if people do in the en

I actually have 5 mk3s+. Upgrading all of them to mk4, mk4s or later to Core One would put a big hole in my pocket. So I just upgraded two of the mk3s+ to mk4, both to mk4s afterward and one to CoreOne two weeks ago. However, I upgraded only two mk3s I had in stock configuration. Two of the other mk

erm thats a Prusa Mk4s NOT a Original Prusa Mk4s. Anyway, Love the build

Man, I can feel your pain. I got a lemon with MK4S. I was having problems with LCD display going blank out of nowhere, had to replace display and the cable, heater error as the paste fixing the connector cracked, I’ve got mine 3rd heater element right now, I had to replace linear bearings of the bed

I had alignment problems with the outer frame as well. What worked for me was to loosen that entire corner. Align the frame and tighten them down. But seriously, that needs to be fixed. Should not have to deal with that. I have built a MK3S, MK4S x2, Original Enclosure x2, and MMU3 x2. Technically x