Photon Mono M7 MAX

the plate was faulty from the factory and what research i did, and i did a lot (sanding was not my first choice) i was trying to find any other solution (exposure times, bottom layers, lift height & speed, diffrent resin & temps) all the options. even look into contacting anycubic but found several

None of them. The GK3 Ultra is a dumpster fire where they replaced the dual linear rails for a single machined aluminum rail and there's Z axis flex (see J3DTech's video on it). The Mega is an antique still using a matrix LED UV light source, although it's the largest currently. The Jupiter 2 hasn't

Which is why I returned my M7 Max after three weeks of frustration. From what I could gather, apparently it's a combination of the screen being seated ever so slightly too low, and the build plates not being perfectly flat out of box. As if that weren't annoying enough, you can't set a z-offset on t

Well, it’s pretty good, but there are quite a few questionable design choices. The power button is at the back, and even the resin refill is placed there, which makes it inconvenient especially for continuous work. It could have been great, but I still think the Anycubic M7 Max is better in terms of

Hello, I'dont know did you read all posts in this reddit. Will write you down. You can also contact me so i can send you photos from my printer if u need further help. Anycubic Photon Mono M7 Max is just screwed printer with a lot of fatal design mistakes, it's just crazy. I cannot tell is it proble

I don't own it, but according to internet, yes. It's mix of concave build plate near center(sometimes) and of gap. If you google adhesion problems on m7 pro, you will see they all got a problem on the very same spot at center. When you print RERF, 4, 6 and maybe 8 wont stick to plate. I could post d

Best to wait for the Jupiter 2 if you can for a large format (13") printer. Hopefully in addition to 16k, it will support a proper range of anti-aliasing grayscale and at least maintain the Jupiter Z-axis if not improve. The M7 Max is a better built machine, but only 6/7k resolution. Anycubic doesn'

Anycubic QC is trash lately. Get one of you like gambling and losing a lot. S4U has issues around auto-leveling/force sensor system, M7 has it worse as it doesn’t have as many tools to deal with it. The S4U 16K also has an over powered UV light source that makes calibrating a challenge. Saturn 3 non

I had so many issues with my M7 Max. After three weeks of trying to get it to work, I returned it. And I've been printing for years and have had multiple printers, so I know a little bit about what I'm doing lol. From my research, there's a couple issues that result in prints not sticking to the cen

There's a bunch of bookmarks to the right. M7 Max isn't exactly a beginner printer though. Why did your friend sell it cheap? I would run through some basic checks. Check the build plate is flat, Anycubic seems to have issues with QC and lots of plates are being delivered concave. Level the printer