Mars 4

Yeah resin is great if you're down for messing with the goop, I have an OG Elegoo Mars and it still does great work, I can only imagine the newer ones. For me printing is just like, what do you mean I can just get any model of my whims in a few hours or like less then a day? I have an FDM as well an

I see that a Elegoo Mars 5 is 160€, and Saturn 4 is 280€. The Mars is basically a smaller version (ie smaller build plate). Both are pretty good deals. But please note that you need to get a lot of equipment besides the printer, both for safety and post processing. You are not getting away with ~200

This was done with an old Elegoo Mars 3Pro, they are quite cheap. But, be aware, that this is not all you will need. Maybe a cleaning/curing Station, Isopropyl alcohol, protective gear, very important. Also consider setup, where can you vent toxic fumes and so on. I use a indoor growth tent from ama

Elegoo Mars if you're printing minis, the saturn if you're doing statues. From personal experience

contact elegoo , they should send you a new plate :) Or worst case, replacement plates for the mars 4 dont cost much. (btw, mars 4 is not compatible with AA. dont try it, you will get failed prints. Just trying to save you resin :) )

Thanks! I’m using a Elegoo Saturn 4 ultra. That model using a different type of FEP film that helps to blend out layer lines. I also set the layer height really low. My print times are outrageous for the size but I have two Saturns so that makes up for it. If you’re completely new to 3D printing, I

Für Figuren im Funko-Pop-Stil bis 500 Euro gibt es im Grunde zwei Wege. Resin-Drucker liefern die mit Abstand beste Detailqualität und sind deshalb für Figuren die erste Wahl. Modelle wie der Elegoo Mars 4 Ultra, der Anycubic Photon Mono M5s oder der Phrozen Sonic Mini 8K liegen preislich zwischen 3

Elegoo Saturn 3 \ Saturn 3 ultra if you need smth bigger. Elegoo mars 4 ultra if small one. All 3 are good budget printers. Good resin for minis - Anycubic abs-like pro 2. Durable, tough, pretty cheap

Honestly you are probably missing something basic. Mars 4 is a pretty noob friendly system. I one time was trying to force failed print troubleshooting another printer and the dang little thing would just keep outputting prints in conditions that would have failed any other printer. Did you print th

I use elegoo mars 4. It does it job, it s a rather simple machine. It s also made in china, so expect some problems, and that a few parts (fep but also screen) are consumables that u have to change once in a while. You can get one for fairly cheap and l see very few reasons to buy a more expensive o