Photon Mono M7 MAX

Anycubic QC is trash lately. Get one of you like gambling and losing a lot. S4U has issues around auto-leveling/force sensor system, M7 has it worse as it doesn’t have as many tools to deal with it. The S4U 16K also has an over powered UV light source that makes calibrating a challenge. Saturn 3 non

As I recall the heating on the M7 Max does not work once the print starts, so if your print is in a garage or other space it is getting cold, you might need an additional heater to maintain temperature. Next the larger build area of the Max means the release film comes up a lot higher and thus the l

Will Anycubic update firmware to support multi-exposure printing? Same question for slicer support for multi exposure printing. This can be used to provide extra curing to supports and support interfaces as well as patterned exposures for shrinkage reduction and other material property controls. Wha

There’s really only 4 consumer large format printers on the market currently. Anycubic M7 Max - other than resolution, probably the most technically capable printer, except for no per layer wait times (Anycubic doing Anycubic things). Anycubic QC is sad these days, check the build plate if you get o

The issue is most likely not the resin settings. The light off delay is just good practice in general as I find it improvs print quality by a margin. Two things I always recommend. Flex plate is no1. but 2nd is increased light off delay to allow resin to flow. For your issues. My money is on the pla