Photon Mono 4 Ultra 10K

Avoid the R6 like the plague. Personally I prefer Elegoo over Anycubic for printers, so I would lean Mars 4, however there are trade offs. The Mars 4 has a better light source (COB vs Matrix). It's been said the Mono 4's matrix LED light source does the 10K LCD no favors (less even, wider angle of i

I may have to go in manually then if these prints keep failing. It’s frustrating; it’s literally hit or miss for me and it’s killed 2 FEP films and a screen for my Anycubic Mono 4 ultra

I would check flatness for both the build plate and the top plate (the part that holds the LCD). Anycubic have a real issue right now with QC and shipping concave build plates, and I know someone who bought and returned 2 Mono 4 Ultras (months apart) for the top plate being warped.

Man I gotta save my comments. I'd pass on the Mono 4, it's an antique design with a 10K LCD slapped on top (it's basically identical to the previous Mono 2 4K printer, and even that was already long in the tooth design wise). Pass on the Mono 4 Ultra due to QC issues. Warped top plate being one. Con

I’m using a Mono 4 ultra, .09mm per layer height, a burn in time of 60 layers for 40 seconds and lift travel of 6mm, and speeds of 3mm/s. I use anycubic eco resin 2.0, the resin is heard to 18-19°C, but I used to have zero problems until this weekend when everything went to hell in a hand basket If

I got my Mono 4 Ultra last week. The Anycubic slicer is not really good. So I trying Lychee, but I can not open the sliced data. I can only open .stl or .obj . Do I something wrong? Or is this a general problem? And if I do something wrong, please help me. Sorry for my bad English.

Hello. Any updates? Here is my post about fan. https://www.reddit.com/r/resinprinting/comments/1mmebiq/anycubic_photon_mono_4_ultra_fan_noise/ But now i can't even open a manufacturer website and find any information about this fan except I posted already. Airflow(CFM) - 5. Static Pressure(mm-H2O) - 24.20

Forna small format printer, Mars 4 Ultra if available, or Mars 5 Ultra if the Mars 4 Ultra isn’t available. I’d avoid Anycubic for multiple reasons, not least of which is the Mono 4 is an antique with a 10K LCD shoved into it. Mono 4 Ultra is a more modern design, but Anycubic QC issues make it hard

Had a similar problem with my anycubic photon mono 4 ultra. LCD was damage

Mono 4 is an antique system with a new 10K LCD put over the top. Anycubic's quality control is a bit in the dumps currently. Mono 4 Ultra especially I've seen some bad QC from others. Mars 4 is fine except for the lack of anti-aliasing. Mars 4 Ultra has AA support, but comes with ACF release film by