SV06 ACE

I just packed up my V3 PLUS.... the spool holder is a nightmare,,, printed that fix...top holder...had to babysit the z offset every time... especially on PETG... adhesion was good but ugly... tried the help desk for mesh problems... they would not believe me.... had to take pictures .. videos.. blo

They are the absolute worst when it comes to customer service. I have a Q2 that likes to nose dive into the build plate at first home sometimes. After the first time it did it very aggressively and it didn't stop so I hit the power button on back and figured I must have imagined it. Second time I wa

Ein wenig Geduld bei der Suche zahlt sich da oft aus, ich hab 50 EUR bezahlt, und der hatte weniger als 100h Druckzeit. Kannst du den für 90 vor Ort anschauen und abholen, inkl. kurzer Vorführung? Meiner wurde ja als Defekt versendet, ich war überrascht, daß der problemlos lief. Aufpassen bei der Su

At least you know it isn't the slicer, so it must be mechanical or filament, sounds like it isn't filament so logic says mechanical? Have you tried a small cylinder (say 40mm high) in vase and ordinary mode (ie no fill) I have a sovol sv06 ace and have endless faults with it (seriously think I've go

I have mine in this Yoopai enclosure, though I almost never zip it closed. I mostly just print PLA/PETG and TPU. For PLA and TPU I keep the flap completely open, but for PETG I will close the flap but keep it unzipped, that way I can avoid drafts but don't have to heat the whole room so much. My SV0

Avoid elevation at all costs. Their printers are mid quality at best, and their firmware violates the GPL 3.0 license of Klipper. Bambu is decent, but their locked down ecosystem is why I avoid them, but that isn't the most important for most users. I recommend Sticking with the A1 Going for a Sovol