Q2C

Die Filtersysteme der meisten Drucker sind Alibi-Argumente. Da hängt ein HEPA/AKtivkohle-Filter drin und jeder denkt "Jetzt bin ich sicher". Nur es wird halt vergessen, dass der Filter getauscht werden sollte und dass der Exhaust-Fan auch an sein soll, damit die Luft durch den Filter gezogen wird. U

Bambu is more plug and play, but not by a huge amount (unlike, say, a Creality Ender 3). The Q1P and I think the Plus 4 shocked people because the chamber heaters weren't properly shielded. The Q2 shielded the chamber heater to fix that (and the whole printer has a top tier safety certification that

The hotend part I'm not sure I would say the CC2 is any better. Yes it goes to 350C but make sure your really going to be using those type of filaments. Those are not cheap filaments. As far as chamber temps most of te filaments that really need those super high nozzle temps also need high chamber t

If its indoors and near you, its quite loud. If you dont print anything besides PLA/PETG I think it doesnt suit you. My ten cents after two weeks. I know what I got into and its fine for me. Im using it in my garage which has sub freeze temps during winter. Heated chamber is a bliss when ambient tem

I have a P1S and it's been great. The only advantage that I see the Qidi Q2 or Q2C have is the ability to print PPS-CF. If you intend on input printing PLA and PETG, P1S is great. It prints other engineering filaments well, but does not have a heated chamber and higher nozzle temp like the Q2.