XL

Yeah, it’s on the back of a single YouTube influencer who experienced adhesion issues, did a similar scan and deduced that the adhesion issues were caused by poorly designed bed heating. He also compared it to a Prusa XL that didn’t show the same ‘issues’…but which uses a completely different form o

A couple points: The smaller XY dimensions relative to the X2 is not terribly substantial, and even smaller after accounting for Bambu's calibration processes using up more bed area than prusa's prime line. The H2 is a whole different size class, closer to the XL (With the core one L somewhat smalle

I am not sure for your first issue as I do not own a MMU but I own a 5H XL which runs the same firmware obviously... When starting the print you can rearrange the Filaments.. so replace head1 with head3 for example, I suspect this is the same for the MMU... Instead of replace I can tell it to join a

Well some reviews showed that it was much worse than the Creality K2 Plus or the Prusa XL. X1Plus also showed me, how bad my bed is. For me, I have a combi plate with G10 and textured PEI. Due to the G10 sheet it is quite a bit flatter, so I use that for parts that need flat bottom parts. But, if I