T1 Max

I heard back from FLSun. Support last week, trying to find an Effector base plate for my T1 Pro that has one stripped screw hole for arm retention. They said out of stock but will let me know if they find some. At least I got a response quickly, so many on here saying they are swirling the drain. Th

All be forewarned on FLSun, we have 2 T1 printers, both failed within the factory warranty period but FLSun refused to repair or send parts on the warranty. They dropped support for the T1 when they introduced the T1Max. If you buy the T1, make sure to get the Micro Center extended warranty.

Story time! I bought a t1-u in December and it burnt out in April. Begged for service and they shipped my printer to nj and back and there it was upgraded to the t1 pro T1 pro worked until July until the same motherboard burnt out. This time they wouldn’t refund me so I had to make posts online unti

Been hearing a lot lately about flsun ghosting. Makes me want to out my t1 pro on ice for a bit in case I need parts. As far as i know these machines can be flashed back to previous firmware but I could be wrong, been a while since I was told that. If you updated through the machine screen you may b

Don't.. T1 and S1 aren't made for those kinds of materials, and they never claimed they were. You're gonna destroy your hotend/heatblock, and flsun doesn't have any replacement parts in stock.

I have had a T1 Pro now for about 6 months. The hot end heater died second week in (many people had this issue). After replacing that it has run nearly every day without issues that are not typical of all printers. Right now I am having some major first layer issues that I cannot seem to get right n

It should work the T1 Pro motherboard with the T1 at least that’s what I’ve been told but after many attempts of trying to get ahold of FLSUN I am getting a new 1 on warranty. Couple of tips I’m doing is a bigger fan for more better cooling and apparently if you under volt the drivers helps with coo

(Part 2) Yes Elgoo carbon "CAN" be loud -- in all fairness and rainbows (as reported when fans are MAXED 100%)... but for normal PLA operating the DBs sound is less then ~50dbs or LESS - likely less, 40's dbs to be fully fair, and no bias... but again, its NOT 65-70+dbs ALL THE TIME like the FLSun T

All I want from SSH access is to add my T1pro to octoeverywhere. It's all great that they have an app that can monitor the printer, but I have 11 printers. I can monitor everything except my prusa XL, mars5 ultra, and the T1 through octoeverywhere. Prusa makes sense. but I feel like there's no excus

I had a t1u which broke after 4 months. The t1 pro they replaced it with broke after 2 months, and I haven’t had a printer for the last 2 months because of issues contacting FLSUN.