S1 Pro

Check the sliced previews. More specifically the layer time, flow, and speed previews. If your layer time preview has the same pattern, try changing your infill type to rectilinear. Check the preview again. If it looks even, or better than it was, try printing it to see if the banding goes away. Sou

Install Viking3DK Orca profiles to get high print quality. https://www.printables.com/model/1426214-flsun-s1-s1pro-orca-profiles-v10/related

AI to the rescue The FLSUN S1 and S1 Pro are both high-speed delta 3D printers, and they share many core features. However, the S1 Pro is an updated version that brings several key improvements and refinements. Think of it less as a complete overhaul and more as an "S1.5" with enhancements that impr

I have an S1 pro and I'm feeling the same. Not quite giving it away yet, but I'm on effector #3 and it worked all of 1 second before getting a clog that required full disassembly. FLSUN support hasn't responded to my email (it's been weeks). Printer has been down probably 8.5 of the ten months I've

All printers have their place. For mass production my Bambus are my go to but for prototyping my FLSun S1 pro is by far the better machine

My s1 i got before release from flsun still beats the flsun s1 pro I have and when set right and slowed down is super clean especially being open source as well. If it had interchangeable heads for multicolor and a circular camera ring to auto 3d scan it would kill with its built in lidar and full b

I love my S1 Pro, though it took a week of dialing in and figuring out settings to make it print at a similar quality to my Bambu A1 Mini. But once that was figured out, it’s been great! Print quality is fantastic and it’s so fast, even with my setting tuned to favor print quality! One thing I’ve ex

Thank you for the tip. I've kept it dry, and even dried it before prining. Unlike PLA, which degrades due to moisture, PETG can be restored by drying. I used the same filament to print the wheel on a different printer (at 10:35 in the video), and there was much much less stringing - barely any. My t

The biggest issue I had with the S1 even after the motor upgrades is the persistant salmon skin that would materalize on the outer wall of every print when you print at slower speeds, especially vase mode. After a year of troubleshooting with FLSUN including firmware updates of motors with a spcial

I have a S1 Pro and it has been pretty solid. I would highly recommend getting "high speed" filaments. I have had good luck with Sunlu's HS PLA and Elegoo's Rapid PETG with just default profiles (using OrcaSlicer). I haven't used other filament types outside of that. Be prepared for how loud it is.