AD5M

I haven’t had any issues with the 5M pro’s software, I would recommend downloading OrcaFlashforge for the slicer since it is optimized, and the only thing that will get to be annoying is that it will constantly log you out of your account. The mobile and pc ui for the flash forge app sucks and is re

I reached out to FF Support looking for some announcement or additional details on the new software and firmware releases. I asked to receive the update files, or be in on the beta group, and explained some users were in a broken state because only one of their devices/softwares updated. The respons

I have the FlashForge AD5M and the Elegoo Centauri Carbon. I would buy the CC over the AD5M every single time. The bigger build volume is one, and the primary one, it matches the Bambulab X1C so a lot more prints are possible that are designed for that build volume, the other is that with the CC I h

The only access to the firmware updates for Flash Studio is currently through being added as an internal tester within the scope of the application. I received word after putting a feedback request in that my AD5M had been added to the list of internal testing devices and I was able to update my fir

Since you’re using a FlashForge, are you using the Flashforge Orca Slicer? I just got an AD5M and had to swap to using the open source Orca Slicer to get decent prints out. The software was causing my prints to come out wrong, similar to yours, for some reason. Once I swapped I had no issues.

I have both a P1S and a FlashForge AD5M Pro. Get the P1S. It’s a considerably better printing experience. I have found the Flashforge to be a bit of a pain in the ass to be honest. The software is just garbage unfortunately.

I have always had adhesion issues with my flash forge. Cleaning with dish soap, rinsing thoroughly, and sometimes I even spray with 90% isopropyl alcohol just to be sure. I still need bed glue almost all the time. This is definitely something about the flash forge. When I put the same filament and p