Deebot N8 Pro

Following this because I’ll be updating this year from an Ecovacs N8 Pro. I will never buy another Ecovacs.

In my research it's not exclusive to any one brand. My old ecovacs n8 has the same issue. I usually get around it by moving the robovac to a different area and then it eventually recognises where it is. Sometimes I have to repeat the process requiring me to delete the new temporary map it was buildi

Ik heb de ecovacs n8+, deze deed het 2 jaar super, tot ook dat tandwiel stuk ging. Ik heb een nieuwe ge 3d-print, omdat er geen garantie was en ik geen reserve onderdelen kon vinden. Nu is het tandwiel aan de andere kant ook stuk, en werkt de lidar sensor niet goed meer (robot is constant verdwaald)

Generally, I don't recommend Ecovacs anymore. The hardware and ideas are great but the software is just... bad. I have an x2, and when it does clean, it cleans well but 80% of the time it'll suck something in, trap itself or just completely ignore some parts of the map. Even the Ecovacs n8 was wayy

Same issue on two ecovacs deebot N8+. As mentioned, there is no real solution except to delete map and remap or pick it up, dock it, and restart vacuuming to reset the new overlay. It’s annoying - yes.

I have the N8 pro plus and it still can perform a basic vacuuming. But it has flaws which should have been fixed but I guess they just left the platform and went on to make newer models. Not fixing simple issues in older models might point to that the models don't share a software platform. Instead

Just had my Ecovacs Deebot N8 Pro+ flake out after four years. It loses the internet and crashes within minutes of leaving the dock. Seems like a firmware or server issue. Contacted Ecovacs support to get more info. After several email exchanges over about a week, and requiring me to jump through mu