A1 Mini

TLDR: A component called a NTC thermistor on the AC board can overheat and catch fire. In some cases it melts through the bottom of the A1. 3D Musketeers have collected 70 reports of this problem. BambuLab remains silent on the issue. If you run a A1 please place it on a non-flammable surface.

Yes, this could've caused a fire, BUT I have yet to see a fire being caused by a bambulab printer (PLEASE correct me if I'm wrong). That said, never turn this back on again and contact support. Edit: I keep getting replies on this with people apparently not understanding what 'fire' means. Like some

Don’t even talk to them about repairing it, demand a replacement printer or your money back. Include the pictures you posted here if you haven’t already. Explain exactly what happened since you unboxed it, and that it’s a brand new printer that’s a fire hazard/defective and unusable. Where exactly d

Da steht aufm bildschirm, die Düse ist mit Filament oder die Druckplatte falsch eingesetzt. Entfern mal den ganzen Blödsinn von deiner Druckerplatte. Vielleicht liegt da das Problem. Ansonsten kann das auch ein Problem mit den ganzen Erkennungsfunktionen sein. Geh im Drucker unter einstellungen in D

How old? The factory heater block is trash and falls apart over time. Does the nozzle flex? Pull the nozzle off and the heater block off, check if the carbon fiber is falling apart. If it is, the pressure sensor for bed leveling is going to be wack because the nozzle is flexing. https://wiki.bambula