Kobra X

Keep in mind you’re essentially a beta tester with the Kobra X, its initial presentation might look promising but it’s not proven long term. My personal experience with Anycubic has not been reliable or trustworthy. After a Kobra 2 and a Kobra S1, I wouldn’t trust anything they make anymore. They’re

So far, honestly, my experience with the Kobra X has been very positive. I was a bit cautious at first too, mainly because Anycubic’s older reputation made me expect some headaches after the first weeks, but this machine has actually surprised me in a good way. It’s been reliable, prints consistentl

I seem to be the odd man out. I have a Snapmaker U1 and it has not work since day 1. Snapmaker has been aware if the problems and still done nothing to address them. Feeder issues toolhead issues software issues you name it. I have no resolution to the problems. My P1S with 4,000 hours no problems.

Flashforge sucks. Literally any other brand is worth while. Look at the Anycubic Kobra X, love mine, it’s been a fantastic printer.

Die Frage ist, was du drucken willst und wie groß. Und ob du mehrfarbig drucken willst. Der Kobra X ist ein Bettschubser, offen. Braucht wegen des sich vor und zurück bewegenden Bettes mehr Platz in der Tiefe. Kein Gehäuse, also sind bestimmte Materialien schwierig oder gar nicht druckbar (ASA/ABS w

Yeah, I’ve seen that behavior with large PETG prints too — not really a “Kobra X issue” as much as PETG + full-bed coverage being a worst-case combo 😄 On my side, the machine itself has been very reliable. The only time I ran into something similar was with big, edge-to-edge prints where internal st

So I own the Kobra X. But it is not my first printer. It's my 4th actually. I've had mostly positive experiences but note I did have to replace the hot end under warranty which support was easy to work with and sent new part free of charge. If you are new to 3d printing such troubleshooting and repa

The first 3D printer I bought was an Anycubic Kobra X. I purchased it along with three spools of filament in February as part of a promotional offer and then had to wait until April to receive it. It was a long wait, but they communicated the estimated delivery time when I placed the order and sent

I only have the Kobra X. And outside of one issue with my hot end (replaced under warranty) the machine has been fine. I had issues with the leveling system but a machine factory reset cleared it. This was right after a firmware upgrade so it must have gotten bugged. From reputation Anycubic seems t

Anycubic has its own share of issues, but the Kobra X seems to be a black swan coming from them.