Kobra S1 Combo

Dude. Upgrade that dang ender first. It’ll surprise the hell out of you. The upgrades available today are 10x better than what was available back in 2020 🙌 my e3pro has the 4.2.7 silent board running a basic compile of marlin 2.0.1, dual z, MS direct drive kit, TH3D EZABL Pro (installed, not connect

That’s an interesting assumption. You’d be wrong. But interesting nonetheless. Honestly, no clue what caused and I likely won’t until I get the blob off and take a look at the nozzle. I had this happen on my old Anycubic Kobra S1 printing PETG-CF and it was because the nozzle started leaking (someth

A bed like that is probably easily corrected by adjusting the z-screws. Though this should've been done at the factory. https://wiki.anycubic.com/en/fdm-3d-printer/kobra-s1-combo/nozzle-scraping-hot-bed

You can troubleshoot it but if you have it under warranty, claim it and just get a replacement. The beds often taco themselves (I bought funssor bed and gantry to solve this issue) and the hotends are extremely bad (I bought microswiss to solve this). If you want it working as advertised you do have

before the P2S Combo i owned the Kobra S1 Combo for 11 Months & 650 hours. YOU DODGED A BULLET. The Printer is even worse than a OG Ender. You cant even Troubleshoot problems cause the problems are random AF. Like first Print will fail horrificly and if you press Print again without changing ANYTHIN

giant mistake. I also made this mistake with my Kobra s1 combo. 650h of wasted filaments and constant problems. If you even do a little research you find quickly find out to avoid anycubic. I got scammed from all Anycubic reddits and anycubic themselves. Go with the elegoo CC. i know tons of people

Unfortunately, I have experience recently with this assembly. I definitely see an extruder screw missing on the mid-right. May be good to check out these pictures and videos from AnyCubic. https://wiki.anycubic.com/en/fdm-3d-printer/kobra-s1-combo/extruder-module-replacement-guide

Some specs I listed here:- Print volume (mm^3):-- P1S: 256x256x256-- S1: 250x250x250-- K2: 260x260x260- Max tool head speed (mm/s):-- P1S: 500-- S1: 600-- K2: 600- Max tool head acceleration (mm/s^2):-- All: 20,000- Max flow rate of hotend (mm^3/s):-- P1S: 32-- S1: 36-- K2: 40- Max Nozzle temp (C):-

For Z and Y, it's fine, but Y doesn't need much at all, Z a bit more. Do NOT lubricate X! As per wiki: The X-axis assembly is composed of an optical axis and a graphene bearing sleeve, and graphene itself has a lubricating effect. Therefore, the optical axis of the X-axis cannot be greased. When ins

I own a Kobra S1 Combo and a Kobra S1 Max Combo, amongst other printers. To be honest, I had a lot of problems initially with my S1. Mostly with the bed not being level and with it warping and becoming even less level once it heated up. The dreaded "taco bed." It's a common issue and has never been