Deco X55

Det aller beste er jo om du kan trekke fysiske kabler gjennom etasjene, men om du ikke skal gjøre noe veldig krevende kan jo mesh være en grei løsning. Vi bruker TP-Link Deco X55 over to etasjer og en kjeller. Det gir oss en enhet i hver etasje, og grei dekning. Guttungen spiller i kjelleren, og har

You already have a 802.11ax AP. If you're happy with it's WiFi use the Deco X55 Pro as an access point behind your RB5009.

Not saying we should ignore this problem but TP Link is one of the cheaper hardware so there you go. I have Deco x55 and i do receive 2 firmware update so far on its entire 1 year cycle. If you want something pro privacy, than you would have to, most likely, go with more expensive brand

are you comfortable setting up Mikrotik RB5009UG as your primary router and using omada switches/ap or you're just looking for consumer mesh system? You can try TP Link Deco X55 or Deco BE23. What is your budget?

You are welcome. My old router gave up the ghost before Christmas, so now my house is running mesh on TpLink Deco x55. Love the coverage, just not the upsell for premium monitoring.

Brother in law upgraded his old nest to the new, both were flaky and dropping connected units. I gave him my deco X55 ax 3000 three piece set and he hasn't had any trouble, nor did I. I upgraded to unifi system for extra control/features.

Your setup is actually really solid for a first-time mesh install, especially with the MoCA wired backhaul. Using three Deco X55 units in Access Point (AP) mode with each one getting a direct Ethernet feed from the basement router via MoCA adapters is one of the best ways to do this. Wired backhaul

The other advice you got was bad. Hope im not too late. There is nothing wrong with you g4se modem. Its what I use and plan on using for years to come. It has the external antenna port that I have hooked up to a waveform antenna. If your internet wasn't good enough that is what id have you do. Get a

I replaced my 3-unit TP-Link AX3000 (Deco X55) mesh setup with two Cudy WR3000S models running OpenWRT, one in dumb AP mode. The only compliant I have is range, and as far as I can tell it’s pretty much just aesthetic - one bar lower in my bedroom, but speeds are fine. My main complaint with the Dec

Mesh has better handover logic between nodes via controller built-in, wifi6 will make it even more efficient... Got a 4-node deco x55 system for the parents 3k sq/ft with wireless backhaul, works well and just got a dual node for my townhouse- no disappointment at all