Deco X20

Even with 5ghz, it is very hard to reach your max speed when you're already at that level. Anyway, found this reddit post about a similar issue to yours. Check and see if the same applies. If hindi mo masolve, 470mbps is already extremely good for wifi. Kadalasan nagiging OC lang tayo kapag hindi na

Cisco y otras marcas también tienen repetidores mesh, por las dudas. Yo tengo dos DecoX20 de tp-link pero vienen más económicos también (la gama P). Tené en cuenta el máximo de ancho de banda que soporta cada uno. La posición del repetidor en la segunda planta (yo tengo el principal conectado por et

Hola todo tranquilo? Laburo en Antel así que capaz q te doy una mano Si el Wifi Max lo querés usar como parte de la red mesh, solo va a funcionar junto al módem/ONT de Antel y además tiene que estar manejando él la red WiFi. Al tenerlo En modo puente no emite la red principal, así que el Wifi Max no

your router is probably the issue if its the standard Telstra one. generally they are trash. Telstra might also be trash but largely NBN its all the same. Superloop I'm a fan of but any of them will be good. get yourself a mesh router setup. either a new one if you want to spend cash or just a secon

Thanks guys! I’ve already ordered a router (Deco X20) for my apartment and it should hopefully solve my internet problems. Sorry for the late update.

Been struggling a lot with this router , so had just 2 options either replace it with Tp Link XC220-G3v or use it in bridge mode, technician called the noc and bridge mode was activated now using my own Deco X20 all the problems are resolved , now full control over Wifi and network

Do you have have dhcp on the main Deco and the ISP modem, that could cause conflicts. You could try adding a 20$ unmanaged switch and have that connected to the Deco AP and the pc to the switch. There is no logical reason why that would make a difference other that I would take some of the workload

my internet is 500mbps up and down. i am getting 380mbps down but 500mbps up when on proxmox with passthrough nic. did troubleshooting and it runs full capability on tplink deco x20. i am hinting nic passtrough is the culprit. so yeah. bare metal all the way. since money to buy baremetal is a concer

Tenho casa dois andares e sistema TPLink Deco x20. Cerca de 40 dispositivos ligados. Até agora estou satisfeito. Inicialmente comecei com 3 e estava satisfeito. Mas como tenho um terreno grande, passei para 5 Decos. Posso dizer que apanho net em todo o lado. De um piso para o outro passei um cabo do

Ini ga jadi masalah, kalau u ga suka pindah2 sambil conference call kerja (misal dari kamar ke ruang tamu). Kalau mesh aman, karena dia akan autoswitching. Pengalaman saya pakai TP Link Deco X20 udah 4 tahunan stabil pakai biznet yang sekarang speed 200 Mbps (dulu awal2 beli mesh, biznetnya masih 60