Deco X20

Yep, Wi-Fi access from the basement in a 3-floor house is always tricky. Even with a mesh setup like Google Nest, thick floors and walls can really mess up the signal, especially upstairs. The first thing I’d try is moving your mesh nodes around. Place one on the ground floor and one upstairs, ideal

I had those same problems with my network of TP Link Deco X20 in mesh. The solution was to pass the Nest speakers to the 2.4GHz network and set the default node to which they must be connected.

A decent mesh with strategically placed access points will probably work just fine here. I like the TP-link Deco X20 if I’m building a non-unifi system.

Hola todo tranquilo? Laburo en Antel así que capaz q te doy una mano Si el Wifi Max lo querés usar como parte de la red mesh, solo va a funcionar junto al módem/ONT de Antel y además tiene que estar manejando él la red WiFi. Al tenerlo En modo puente no emite la red principal, así que el Wifi Max no

Buy tplink deco x20 3 pack

What mode do you plan to use the Deco X20 in? Router or AP? Your description would mean using them in AP mode and would work, keeping your existing router as the gateway for the network. Personally I would also run a cable for the camera in the basement rather than using the second ethernet port on

Cisco y otras marcas también tienen repetidores mesh, por las dudas. Yo tengo dos DecoX20 de tp-link pero vienen más económicos también (la gama P). Tené en cuenta el máximo de ancho de banda que soporta cada uno. La posición del repetidor en la segunda planta (yo tengo el principal conectado por et

I have ATT fiber 1g in the center of the house and i disabled wifi on it so that my Deco x20 mesh can handle all wifi on its own. I have the 3 mesh access points spread through the house so everywhere should get good coverage. I split the 2.4Ghz and 5Ghz networks so the "guest" network is only 2.4gh

I would say have your ISP replace the wifi router. I myself would never use the ISP router's wifi and routing because usually they are really bad. I use external wireless access points instead. Best case is I use the ISP modem in bridge mode to A router that handles and manages all the traffic (I ha

Mesh TP-Link Deco X20, you can stick ethernet cable in the back to convert the wireless, good speeds, even better if you can backbone the nodes with cable.