Archer AX73

I might be wrong, but I think Easymesh access points as I have them configured do talk to each other and move devices between them. My downstairs TP-Link AX73 is acting as a router and the Main device in the EasyMesh setup. Upstairs I have an AX75 configured as a "satellite router" that inherits con

Hello fellow Aussie. ISP supplied router? They are usually junk. I run a TPlink Archer AX73 and a TPlink RE700x mesh extender - no issues. You may or may not need the extender, depending on the size/layout of your house.

Okay I’ll tell you exactly how I approached my case : A night before the task, I registered the complaint next morning they called me and enabled bridge one day after that I went to that house of mine and connected an Ethernet in LAN port 1 to the WAN port of my archer AX73 3b) Note that before this

I get pno lags that I notice, people will say I must get lag but don't play FPS, mainly play souls, Final Fantasy's and ghost of T and Y games I brought the TP-Link Archer AX73 AX5400 Dual Band Gigabit Wi-Fi 6 Router and also added TP-Link RE450 AC1750 Wi-Fi Range Extender- 1 Gigabit Port in my bedr

I haven’t really tinkered much with the Pro lately honestly. Not sure how much the faster chip in the 3 translates to improvements in encoding/decoding the stream. I could fire it up and give it a spin and come back to you. The LCD screens in the Quest 3 are at least an upgrade in clarity (but yes y

You’re welcome! It’s just about local network speed. If you get yourself an AX5400, hookup the PC to it you’re set for $150. I use Virtual Desktop which is fantastic for this. https://www.amazon.com/TP-Link-Archer-AX73-High-Speed-Streaming/dp/B08TH4D3QV I tried the cable thing too and honestly it wa

Har en Archer AX73. den fungerer perfekt med det eneste punkt at man ikke kan fluekneppe indstillinger.

Deco and archer models do not mesh together. The only way to get this to work would be to have the decos in AP mode and leave the archer doing the routing. One of the decos would need to be wired to the ax73 and then put the remaining deco where you need it and it will connect wirelessly to the main

My router is an Archer AX73. Also figured out the problem my MTU was too high on my PS3. It was set to 1500 MTU. Changing from 1500 MTU to Automatic fixed the problem instantly.

I’d read somewhere a recommendation of doing a hard reset when switching from access point to wireless router - is that a thing? And, if so, how do I do it? I agree with that recommendation. Hard reset is the same as returning/resetting to factory defaults. Not familiar with your device but it's gen