Max4

My understanding is that the box works better with the Q2 than the Plus4 since the core specifications of the box were final during the development of the former. I suspect it will be a similar situation with the Max4. Just bear in mind that Qidi decided to close down the source code for the box ear

if its to hold the heatsink, it should never get hot enough with direct contact to melt nylon...if so you would get heat creep before it would fail itself. technically the q1pro uses whats called the 3.0 hotend and the max3 the comes stock with 2.0 and you can upgrade it to the 2.5 hotend with bimet

Your vendetta is palpable, and you’re just wrong. Show me on the doll where they hurt you. I’ve had long-term use of printers from Qidi and Creality where I wish you were correct. Qidi continues dropping turds to this day, and literally just dropped the Max 4 - and it doesn’t work. Even shill review

All good questions! So far, I believe there's 3-4 users out there who have had good results. Temp readings taken at 60c 80c & 100c. 100c readings taken with & without chamber set to 65c since those are predominantly the temps people print at. Significant reductions at 65c chmbr with peizos experienc

I can get my STC to within :02 from all 8 points. Set Orca Adaptive Bed Mesh before the print, the purge line is always perfect (how can I set my actual print to print with the parameters of the purge line?) then most of the time I get maybe 10-15 meters of fine line print, then it decides to leave