#1
Longer
LK5 Pro
9 positive 0 neutral 7 negative
Based on 16 Reddit mentions
$279.99
Buy on Amazon
We may earn a small commission.
Most discussed features
Sentiment summary across the product areas Reddit users mention most.
Reddit mentions
Original Reddit posts and comments behind this analysis.
How dumb am I for letting this happen and what should I do?
Heat to 230c (assuming it’s just PLA), use a pair of snips and just slowly and gently chip away. Worst case scenario you need to get a new hotend/nozzle combo (not that bad) just be patient with it. If it doesn’t move don’t force it. Had to do this with a Longer LK5 Pro and thankfully nothing needed
...ApprehensiveDig2939 in r/BambuLab
July 12, 2026 9:26 PM
1
First 3D printer - apparently no i/o out of the box
Of course! I got mine used in basically unknown condition in a lot of 3 other printers for $150. I cleaned it up, did a full nut and bolt check, cleared the nozzle, replaced the Bowden tube and it’s been a great lil printer. What’s funny and odd though, is one of the other printers is a Longer LK5 P
...ApprehensiveDig2939 in r/AnycubicVyper
June 22, 2026 9:12 PM
1
