K2 Plus

If you accidentally place the loose end under an existing winding when unpacking, this will usually not be noticed immediately, but only after a certain amount of time, as can be seen here, because the outer windings are slightly looser than the inner ones and can react to the tangle for a while unt

I have the k1 Max for over a year and a half and been running like a champ, only issue I’ve ran into is heat creep with PLA (fix is a lid lift) and had some old or poor filament that could never get to print. I’ve also upgrade the thermistor to a PT1000 to reach hotend temps at 350c to start printin

Depende muito do tipo de filamento que queres imprimir. Trabalhei muito tempo com uma Ender3 pro, depois disso comprei uma K2 plus (pelo tamanho e pela câmara aquecida para imprimir ABS) e agora comprei um uma H2S. Se não quer se incomodar, vai de bambulab, a experiência é muito "refinada" comparand

Não tenho experiência com a flashforge, só com Creality e Bambu, pra mim as impressoras modernas da creality (tenho uma K2 plus) são bem similares às da bambu (tenho uma H2S), eu sei que a Elegoo também está com impressoras boas, mas eu nunca trabalhei diretamente com elas. A qualidade de impressão

The creality k2 series? Not to mention the k2 plus has a bigger bed, similar speeds and just as good of print quality Edit:and a higher nozzle temp so you can actually print materials like ppa and not have horrible layer adhesion

So, if you can stomach the price, the Creality K2 plus is pretty user friendly. I’ve had parts warrantied with almost no problems. It prints with a typical .4mm nozzle (which is fine, it’s still high detail), and I print exclusively in ASA which is hard to fine tune, but most people start with PLA o

Have the same exact setup. On the 'zon got a kit named "PTFE Tube Kit, 2.5mm ID×4mm OD, 5M/16.4ft, Compatible with Bambu Lab AMS X1/P1P/A1, CREALITY K2 Plus/Hi, FLASHFORGE 5M, Prusa MMU3 (white PTFE Tube Kit)". Sometimes the couplers are a pain to get the filament thru initially but otherwise fine.

I was on the same boat with you at one point. I started the hobby with a used MK3S+. I currently have a Creality K2 Pro and a Bambu Lab A1 which replaced my MK3S+. The A1 definitely has the better multi colour capabilities with the simplicities of the AMS Lite. I'd imagine the more expensive AMS wil

The original hotend is low quality. You can use a K2Plus hotend. https://www.printables.com/model/1599455-sovol-zeromax-hotend-creality-k2-plus

People who say Bambu printers are the best are untruthful. They are only trying to protect their purchase. I own 3 Creality printers for 2+ years with 0 problems. I purchased a Bambu a1 and after 4 days I am returning because this printer is unworkable. People say Creality is junk and Bambu is the b