Kobra X

Ich kann dir den Anycubic Kobra X empfehlen, ist zwar offen, bringt aber ein Colorsystem für 4 Farben direkt mit. Habe den im Presale für 260 bekommen und bin echt zufrieden mit dem was er leistet. Gerade für Anfänger (bin ich selber) sehr intuitiv zu bedienen. Modelle von Makerworld, etc. ohne Prob

So far, honestly, my experience with the Kobra X has been very positive. I was a bit cautious at first too, mainly because Anycubic’s older reputation made me expect some headaches after the first weeks, but this machine has actually surprised me in a good way. It’s been reliable, prints consistentl

Flashforge sucks. Literally any other brand is worth while. Look at the Anycubic Kobra X, love mine, it’s been a fantastic printer.

The Kobra X is my third printer out of four. Since I also own the S1 Combo, the Kobra 3 and "soon" the S1M I can see how Anycubic has evolved in terms of design, improvements, firmware, and hardware. Unfortunately, there are a few users who have come forward to discuss issues with this printer, but

Yeah, I’ve seen that behavior with large PETG prints too — not really a “Kobra X issue” as much as PETG + full-bed coverage being a worst-case combo 😄 On my side, the machine itself has been very reliable. The only time I ran into something similar was with big, edge-to-edge prints where internal st

So I own the Kobra X. But it is not my first printer. It's my 4th actually. I've had mostly positive experiences but note I did have to replace the hot end under warranty which support was easy to work with and sent new part free of charge. If you are new to 3d printing such troubleshooting and repa

Kobra X , 0.4 , the NUT is M4 Wheels for 1:64 scale None of my older printer even came close to that. So it must be your settings..maybe you need to calibrate teh filament. this was white PLA HS from Anycubic and PETG Standard from Jayo

Anycubic has its own share of issues, but the Kobra X seems to be a black swan coming from them.

Im rockin an Anycubic Kobra 2 Neo, and a Kobra X. The neo definitely needed a lot of fine tuning, Kobra X has been pretty spot on. I print most of my stuff in PLA+, mainly grips and accessories. Once I do more research into barrel liners and get more familiar with print orientation I'll be attemptin

Drucke gerade was, habe wegen feineren gitterlinien ( lüftergitter) auch mal den speed reduzieren müssen..mal sehen , was raus kommt.. links schon sehr gut..rechts geht noch bissel was ( Kobra X mit Anycubic PLA ) . Ist ein Rspi3 Gehäuse