Kobra X

Der A1 ist tatsächlich bereits betagt, das merkt man auch teilweise bei der Bedienung über das Display, da braucht er ab und an mal eine Gedenksekunde. Aber sonst ist das ein hervorragender Drucker: Sehr leise, schönes Schnellwechsel-system für die Düsen, sehr zuverlässig und natürlich weit verbreit

Awesome! But I've downloaded the file and tried to colour in all of the sections, but I ran into an issue that I can best describe as z-fighting you sometimes see in games. When I set a filament for the yellow part of the outer ring, it somehow appears under the black part. Is this a slicer problem?

If you aren’t at all interested in multi color then you absolutely should buy a CC1, but if you might want to do multicolor in the future the Kobra x is a better version of the A1. Disclaimer I only say this about the Kobra X, every other Bambu model is far superior to its comparable anycubic printe

None of the above. Given your use cases and options you posted. And here’s the non fanboy why. I have an Elegoo Saturn 16k resin printer and mine has been trouble free from day 1. 1 support ticket regarding what I observed as a burr on the vat that eventually led to seepage outside the printable are

Hey, I’m using Anycubic Slicer Next my printer arrived yesterday. I don’t have much experience in this world yet, and I wanted to ask you something. Is it normal that when I start a print it drops two “poops”? It fills up the (I’m not sure what it’s called... the place where it leaves the poop and t

simple black block with white lettering.<< Everywhere it is not recommended for beginners to try using TPU95A in multicolor at all . There are very few users who had luck with such. Minimum addon to have for TPU printing is the cut lever extension to ensure it is cut properly https://www.makeronlin