Kobra S1 Combo

I’d still recommend the Bambu Labs P1S in this case. The controversy around Bambu is mainly about their closed ecosystem and the move to block third-party apps, not about the quality or reliability of the printers themselves. As for the Anycubic Kobra S1, I’ve watched a number of reviews and seen qu

I’ve had my X2D for less and a week and so far it’s been flawless. I’m so happy with it. It’s made me realise just how lousy my Anycubic Kobra S1 was and how I can just print and get a quality printed part. Getting a second AMS and the filament track switch was also a good move and I recommend it if

i habe both. Why? U1 for Multicolor or Multimaterial P2S for ABS/ASA for Car Stuff und more. Both can be fitted with a Panda Breath for active Heated Chamber so i only need to buy 1 Heater. And when i do big Prints or Multi part prints i just run them parallel. Also filament Storage & Drying with th

wait for the anycubic X? Or bambu lab a1 combo. Or AD5x. Or you could also wait a little and grab a elegoo centauri carbon 1, they just announced the multicolour system is coming out soon for it. I'd stay far away from the kobra 3 or kobra s1 though, i've personally had horrible experience with them

I use this one: https://cults3d.com/en/3d-model/tool/anycubic-kobra-s1-poop-chute-catch The downside is it doesn’t detach but I chose it because it doesn’t block the fan vent! A lot of them do! Since Anycubic cheaped out on a lot of stuff with this to get the price down, I wouldn’t fancy altering es

Had the Anycubic Kobra S1 for almost 1 year with 650h. STAY AWAY.After a certain amount of Hours the Printer will be Hell and you will Troubleshoot every Print.

for 11 months and 650h with my Kobra S1 Combo which can Print & Dry i always at EVERY Print did Print&Dry with 55C which apparently is to hot. Never had a problem. So you are telling me a Crappy E-Wate Company Anycubic whos Printers dont work can Print&Dry with 0 issues even hat higher PLA Temps but

Jumping in here to echo this. I had 2 Kobra s1 and they were fine for a week. Then they start falling apart, par fan bearings went out on on of the, ace pro filament sensor went out on another, beds were showing signs of warping and couldn’t get a good first layer to save my life. The. Got hit with

Unfortunately, I have experience recently with this assembly. I definitely see an extruder screw missing on the mid-right. May be good to check out these pictures and videos from AnyCubic. https://wiki.anycubic.com/en/fdm-3d-printer/kobra-s1-combo/extruder-module-replacement-guide

Some specs I listed here:- Print volume (mm^3):-- P1S: 256x256x256-- S1: 250x250x250-- K2: 260x260x260- Max tool head speed (mm/s):-- P1S: 500-- S1: 600-- K2: 600- Max tool head acceleration (mm/s^2):-- All: 20,000- Max flow rate of hotend (mm^3/s):-- P1S: 32-- S1: 36-- K2: 40- Max Nozzle temp (C):-