Max4

Yeah, I wouldn't buy an X-max 3 at this point. They are well built printers, but the firmware is multiple years behind and QIDI has no plans of updating it. I personally am putting FreeDi on my Q1, Max3 and Plus4, and will check back in on the Max4 in a years' time. And to that end, I'd wait for at

Agreed. With the exception of bed leveling, my plus 4 has been performing beautifully. It's a capable and reliable workhorse now that I have the beacon installed. I'm actually surprised that they haven't upgraded the plus 4 to the Eddy current sensor on the Q2 and Max4. Want to know what doesn't wor

All good questions! So far, I believe there's 3-4 users out there who have had good results. Temp readings taken at 60c 80c & 100c. 100c readings taken with & without chamber set to 65c since those are predominantly the temps people print at. Significant reductions at 65c chmbr with peizos experienc

I think the problem of early adoption is that you can end up with junk. Everybody saw it coming though. Review videos for Q2 all said the product wasn't ready. The issue here is that Qidi abandons their products after 3 months, and that in that 3 months timeframe they didn't even have the time to ac

Be prepared to tinker with temp settings to get optimal prints. Everyone says support is great. I was considering a Max4 but went with the H2S. The difference for me was getting a Microcenter warranty and the H2S has been in market longer. The QIDI Box can do abrasives, but it can be involved removi