Adventurer 5M Pro

The biggest issue with me now is, I've had 3 prints stopped mid cycle due to "E0017 move queue overflow",Official remedy is to reduce the print speed, which I think is ridiculous...The recovery function works a treat but would prefer to have a print complete all the way through, Forge-x has a fix fo

Adventurer 5M Pro:How orca-flashforge works for me via PC. You will not be able to use the flash maker app with this method. Every single time the printer goes idle or turns off, through orca-flashforge, I have to go to devices tab > device list > press the arrow with the square to remove/disconnect

This isnt very helpful but I've never been able to get my ad5m pro to print from my computer only from usb, I think its honestly just a fault with the flashforge hardware or something cause I've heard this happen with many others using the similar flashforge platforms.

I got a lot of stringing and a lot of it just clogging the nozzle after 20 minutes or way less.I got it three weeks ago, used to work fine ish like 2 weeks ago but i my ad5m pro…on multiple different nozzles on multiple different settings, using flashforge pla multiple different brands. The 0.25 lit

Ich habe einen Flashforge Adventurer 5M pro. Der drückt gut und zuverlässig, würde ihn aber nicht nochmal kaufen, weil er sich schwer automatisieren lässt und der Slicer nicht viel kann. Für die Nutzung mit Orcaslicer muss man viel mit USB raumfummeln, das ist nicht optimal. Für Plug und Play Druck

J'ai une adventurer 5M pro de decembre 2025. Firmware d'origine 2.7.5 (non dispo sur le site mais le sav me l'a envoyé sur demande)j'ai testé les firmwares 2.x.x / 3.x.x / 5.14 mais pas le tout dernier 5.1.7. Jusqu'à maintenant, aucun upgrade n'a marché et l'imprimante reste bloquée sur le logo flas

Absolutely not, it's an artifact which I call "flashforge surface blight" which affects the printing of exterior walls. Nobody has completely explained what causes it, I've tried capturing it on high speed video. If you look at it as it's printed layer by layer, the artifact is caused by the extrude

Hi, I'm from the google search future. This happens on my flashforge adventurer 5m pro. It only happens when activating the internal webcam. It became such a reliable problem that I invested in an external wifi camera, since installing which I've had 0 3d prints fail except for in the case of runnin

I have half of the enclosure (top panel and one side panel facing me) done for my AD5M non-pro (but I'm assuming that the factory uses the same fans, so I think this will still be helpful to you), along with a couple of mods for the fans, and last time I did a noise level reading at about 10 feet aw