Adventurer 5M Pro

If we’re considering just materials alone then yea I clear the cost of most other aftermarket hardtops by a good sum. I bought a printing setup that can churn out all the plastic I need for this project relatively quick which is three printers but I chalked those up to business expenses as I plan on

Okay no one's recommended this but I have the Flashforge Adventure 5m Pro which is fully enclosed. I'm happy with my printer I have almost 400 hours of printing on it now and only a handful of failed prints and I would say all that isn't related to the printer itself, one of it was a design I tried

Welcome! Figure Feedback on YouTube has a whole playlist on the AD5M/Pro. Yes, the minimal enclosure is a better way to go. It uses much less material. https://www.printables.com/model/1247920-new-v30-of-top-riser-set-for-flashforge-adventurer This model is another "must have", to hold the front fac

If you're thinking of pulling the trigger on the adventurer 5m pro, sometimes Flashforge has sales. Especially with the ADXM out now, the price of the 5m pro shouldn't be too high. There's always the route of buying the 5m and printing the enclosure for a fraction of the difference (although you do

I have two EN4Pros. These printers need a bit of TLC while you dial them in. I have been printing with ABS all along (over 2 years) in a custom enclosure I made. The printer also benefits from some upgrades. Silicone spacers under the bed are a must, otherwise you will keep re-leveling. Linear rails

You might want to check out the Flashforge Adventurer 5M Pro (if you're looking for something enclosed and don't need multi colour printing) or the Flashforge AD5X. They are definitely en par in quality with the A1 and they are super beginner friendly :)

I have the N4Pro (2x) and the N4Max. I replaced the bed springs with silicone spacers (this one is a MUST) and did the linear rails for all of them. XYZ for the Max (it has all POM wheels from the factory) and Z (POM wheels from the factory) only for the Pro, as it already has linear rods to slide o

I got the flashforge adventurer 5m pro, on sale right now for 380 js. Great printer for beginner and the experienced alike. Fast prints and easy to work on. Enclosed which makes it ultra quiet and doesn’t get smelly because of the filtration fans. My first and only printer but I 100% recommend it

I have a FlashForge Adventurer 5M Pro. So far it prints PA6-CF without too many issues. I bought it because my nephew got one for Christmas and had questions about his. I had been looking for an excuse to get a 3D printer to start on some 3D2A stuff, so I struck while the iron was hot and my wife wa