Neptune 3 Pro

From my experience, it is both easier and worth replacing the hotend after an event like this happens because even after you clear out the blob, its possible there could be additional structural damage which can't be fixed without replacement. I recommend contacting Elegoo Support, sharing these ima

I have a Neptune 3 pro, 4 and 4 max. My 2 cents are, that if you're not technically inclined. Look for another printer. The elegoos require constant tuning and calibrating. When it works it's chefs kiss but when it doesnt, you'll waste and entire day troubleshooting and recalibrating.

This is what kept happening to any of my matte filament. But now I’m wondering if my nozzle was just really built up cause yeah that needle was stuck good before it snapped off inside. 😩 I swear I’m not even new to printing lmao. This is my 3 machine over the last 5 years. I went from an Elegoo Nept

Most of the advice here is sound, though may seem a little brief.It does look like you have Z-offset issues on this print, but also that the printbed is not level. Each foot of the tower has a different z-offset, with one being close to correct and the foot opposite being the most away from true.htt