K2

Correct. Thats the bed holder of the k2 plus. Its broken! You are also missing the bed plate. That e bay seller is lying, its not supposed to be like that. You should know fixing this is a real PITA. You can fix it with screws and epoxy, or replace the entire side piece which would involve unscrewin

Totally agreed. I got rid of my X1C and P1S prematurely after the H2D was released. I was hoping for a much bigger build volume, so I picked up the K2 Plus. I said the same thing - it's straight up hot garbage. The touch input is laggy, the CFS seems nice but sadly for me it was just trash. I've had

BM0111 is not a random error – it's a communication failure between the toolhead and the mainboard. Since you've already replaced: the toolhead cable the toolhead board the issue is very likely NOT in the toolhead itself. From my experience with the K2 Plus architecture, the most common remaining ca

I got an ender 3 s1 plus, it printed well and without hassles. I bought a k2 plus, and now have 3 cfs. The k2 shows that there are issues with quality control. It is a complex machine, with lots of components, there are always going to be bits that get missed, or fail. Support is painfully slow if e

Das ist jetzt zwar hörensagen aus der Creality community, aber der K2 neigt wohl zum Verstopfen, gerade bei allem wo nicht pla drauf steht. Wenn das ein Firmwareproblem war, kann man es zwar fixen, aber es könnte auch ein ungünstiger filamentweg durch den Druckkopf sein. Außerdem ist der Creality su

That sounds really frustrating, especially after such a short time of use. With the Creality K2 Combo, FR errors are often sensor or wiring related, but at this point you have already done more than enough troubleshooting. I would escalate again with all your documentation and clearly request a repa