Ender 3

Ya the issue mainly is people dont want to tinker and tune when they buy a product. Especially when they see printers now like bambu which basically just work perfect out of the box. You also pay for that pleasure. Ive had friends ask me if they should get into 3d printing or should they get an ende

My Ender 3v2 has been working pretty flawlessly and consistent over the last 3 years I had it. Upgrades I made directly out of the box: Auto Bed Leveling usingthe CR Touch upgrade from Creality replaced the bed leveling springs with silicone washers (also from Creality) replaced the plastic filament

I know this isn't what your asking for, but for what it's worth.... I tried every leveling "trick" in the book with my original Ender. I even mounted a dial caliper to the print head and leveled that way to be SUPER precise. I only quit having adhesion issues when: I upgraded my bed with a good piec

Yes, you can klipper on anything Linux! Use KIAUH (Klipper Installation And Update Helper). Even on Arch btw😈 Yes you can get live data from Klipper, it’s a very mature ecosystem! Just give it a go! About the 3rd ;I have seen people do this and I want to try but for now I do a SCREWS_TILT_CALCULATE (k

Try the Mricsoc firmware, i use it since a few years. Get an autolevelprobe, install it, chnage the software to mriscoc, calibrate the printer and thats it. You can use the formware without installing an autolevelprobe. You can use a cheap chinese one or the creality one. The standardbed of the ende

I love mine, but don't buy that. 1st gen doesn't have automatic bed leveling, and the heaters run off 12v. It takes ~10 minutes to preheat the bed and nozzle, so you won't really test much in 5 minutes. Creality sells factory refurbished Ender 3 V3 SE on eBay for $86 delivered to the US. It comes wi

Update: I Figured it out. After installing the Creality Sprite, there was a peripheral that needed a major change. Estepps/mm needed to be changed from 0.0 to 424.9 specifically. Made this adjustment and found a kick ass Cura profile specifically for the Ender 3 pro and holy shit, is she printing li

I'm glad to know that I didn't fuck up the assembly process and that having to manually level the printbed all the time is just par for the course on the creality ender 3

After you install the CRtouch sensor, you want to remove the Z limit switch completely. Disconnect it from the frame of the printer and disconnect the wires from the mainboard. The next thing you need to do is update the firmware to a version that supports your mainboard with a CRtouch added. In the

That's both a bad joke and not true. A properly assembled ender3 will spit out good prints. Assemble iti once like 3dprintedtombofhorrors does with his ender3V2. Start printing. Mine had yellow bedsprings for a rock solid level (good for 3 month without touching), a bimetal heatbreak and a PEI sheet