Photon Mono M5s Pro

That's this page, correct? https://store.anycubic.com/products/adapter-1 Unfortunately, this isn't the adapter for your model. Though it says it's for the Photon Series, implying all Photon mosel printers, it's actually only compatible with a very skint few models, listed on the page (Air Heat& Pure

I did the light test with a bar blade and I had a very slight (maybe less than 1mm) light shine through. I can't guarantee the problem was with the plate or the blade however. I don't own anything like a steel rule or a tri-square so it would come out of pocket to test it again. I use a 32gb stick I

I can’t speak for the S1 combo. Mixed bag here. Initially - I bought a refurbed Anycubic Mono M5s Pro, resin leak newb error, they wanted parts shipped from China and tariffs were in full effect so it wasn’t worth repairing. I stripped it down salvaged the UV array and use it as a cure light. Anycub

Everyone that says yes will have had a failed lcd. E everyone that doesn't say yes will have not had one and everyone who isn't here looking at boards will also have not had one and since that number is likely significantly higher than the number of people that say yes, there's just literally no way

I too got the m5s pro in August of last year. I've had a lot of success with print quality and general reliability, HOWEVER: ever since new, the touch screen has been quite finicky , but not to worry, I was one of the lucky ones that managed, with difficulty, to make the wifi work to my satisfaction